Start with card base of Berry Burst card stock-5 ½ x 6 inches and score at 4 ¼ inches. The front will be less than the back because the DSP will be attached to the front of the card.
Cut a 3-inch strip from the Flowering Zinnia DSP-use the sheet that has the zinnias in a row at the top and bottom of the sheet of paper. Then cut the DSP so you have two front panels; the panels will be 3 x 6 inches each.
Using one panel of the Flowering Zinnia DSP, cut a ½ inch strip from the bottom of the panel and save that strip for the inside of the card.
Measure ½ inch from the right side of the front of the card and attach the zinnia panel with glue or another adhesive, making sure that the front panel lines up to match the back of the card.
The 1 x 5 ¼ inch panel of Berry Burst is embossed with the Zinnia 3D Embossing Folder and adhered to the left side of the front of the card.
The ½ inch strip of DSP is adhered to the inside 3 x 5-inch layer of white card stock.
The white layer is adhered to the 3 ¼ x 5 ¼ inch layer of Lemon Lime Twist and then all the layers together are adhered to the inside of the card towards the right side of the back panel.
Stamp the front of the envelope and adhere the DSP to the back flap of the envelope.
Stamp the sentiment to the ¾ inch white card stock strip and trim to fit the included Berry Burst card stock strip. Trim both strips and adhere with Stampin Dimensionals to the front of the card.
This card will show both sides of the Flowering Zinnia DSP.
